Start | At-A-Glance | Browse by Day | Author Index

TAL3 Titanium Metallurgy Session I

Wednesday, June 20, 2012: 8:00 AM-12:00 PM
216AB (Charlotte Convention Center)
Session Chairs:
Mr. Rodney R. Boyer and Dr. Don Li
8:00 AM
TAL3.1
Provision of Critical Experimental Results for Emerging Titanium Powder Metallurgy Approaches - From Reduce Cost Powder to Forgings
Dr. Peter Collins, Univeristy of North Texas; Dr. Kamal Akhtar, International Titanium Powder; Peyman Samimi, Univeristy of North Texas; Hamidreza Mohseni, Univeristy of North Texas
8:30 AM
TAL3.2
Rolled Product Form Development and Optimization Using Blended-Elemental Powder-Based Billets of Ti-6AL-4V Alloy
Dr. Sami El-Soudani, The Boeing Company; John Fanning, TIMET; Ms. Megan Harper, TIMET; Dr. Stephen P. Fox, TIMET; Dr. Vladimir S. Moxson, Advanced Materials, Inc.; Dr. Vlad. Duz, Advanced Materials, Inc.
9:00 AM
TAL3.3
Development and Optimization of Rolled Product Forms Using Blended-Elemental Powder-Based Ti-6AL-4V Alloy
Dr. Sami El-Soudani, The Boeing Company; Dr. Kuang-O (Oscar) Yu, RTI International Metals, Inc; Ernie M. Crist, RTI International Metals, Inc; Dr. Fusheng Sun, RTI International Metals, Inc; Dr. Vladimir S. Moxson, Advanced Materials, Inc.; Dr. Vlad. Duz, Advanced Materials, Inc.
9:30 AM
TAL3.4
Development of Low Cost Seamless CP-Ti Tubes
Mr. Curt Lavender, Pacific Northwest National Laboratory; Mr. Vineet V. Joshi, Pacific Northwest National Laboratory; Elizabeth V. Stephens, Pacific Northwest National Laboratory; Mr. Bob Johnson, Sandvik Special Metals Corp., Kennewick, WA, USA.; Vladimir S. Moxson, Advanced Materials, Inc.; Vlad. Duz, Advanced Materials, Inc.
10:00 AM
Break
10:30 AM
TAL3.5
Forming Limit Curves for Ti6Al4V Via Pneumatic Stretching
Dr. Fadi Abu-Farha, Penn State Erie; Dr. Louis G. Hector, General Motors R&D Center
11:00 AM
TAL3.6
Comparative Study on the Properties of Ti-6Al-4V Coatings Deposited by High Velocity Thermal Spray Methods
Dr. Christophe Lyphout, University West; Dr. Nicolaie Markocsan, University West; Lars Östergren, Volvo Aero Corporation; Prof. Thomas Klassen, Helmuth-Schmidt-University; Dr. Kurt Binder, Helmut Schmidt University, University of the Federal Armed Forces Hamburg
11:30 AM
TAL3.7
Recent Inventions and Innovations in Induction Heating of Non-Ferrous Alloys
Dr. Valery Rudnev, Inductoheat Inc.
12:00 PM
Lunch
See more of: Titanium
<< Previous Session | Next Session >>