Additive Manufacturing II

Tuesday, April 11, 2017: 8:00 AM-10:00 AM
Room 6 - 7 (Charleston Area Convention Center)
Dr. Zach Loftus, Lockheed Martin Space Systems
8:00 AM
Microstructural and Hardness Evolution of AM 15-5 PH in Response to Conventional Heat Treatments
Ms. Devon Beckett, Naval Air Systems Command
8:30 AM
Impact of selected Heat-Treatments on Strength & Ductility of LPB-F SilmagAl-AlSi7Mg0.6
Mr. Frank Palm, Airbus Group Innovations; Mr. Magnus Ahlfors, Quintus Technologies AB; Mr. Dominik Bauer, Airbus Group Innovations; Mr. Laurenz Ploechl, Quintus Technologies AB
9:00 AM
Stress-Relief Heat Treatment Protocol and δ-Phase Formation in Additively Manufactured Inconel 625
Dr. Eric Lass, National Institute of Standards & Technology; Dr. Mark Stoudt, National Institute of Standards & Technology; Dr. Fan Zhang, National Institute of Standards & Technology; Dr. Lyle Levine, National Institute of Standards & Technology
9:30 AM
ADDITIVE MANUFACTURING COMPLIANT WITH REQUIREMENTS: an ECONOMIC CHALLENGE for DEVELOPMENT of TECHNOLOGY
Mr. Fabian DAVID, STELIA Aerospace
See more of: Technical Program
<< Previous Session | Next Session >>