Additive Manufacturing IV-a

Tuesday, May 8, 2018: 3:30 PM-6:00 PM
Osceola 1-2 (Gaylord Palms Resort )
Mr. Matthew Crill, The Boeing Company
3:30 PM
Tailored Microstructures of SLM Inconel 718 Achieved through Process Parameter Control
Mr. Tait McLouth, The Aerospace Corporation; Dr. Glenn Bean, University of Florida; Dr. David Witkin, The Aerospace Corporation; Scott Sitzman, The Aerospace Corporation; Mr. Paul Adams, The Aerospace Corporation; Dr. Rafael Zaldivar, The Aerospace Corporation
4:00 PM
An Overview of DARPA Open Manufacturing Program: tiFAB
Dr. Andrew Baker, The Boeing Company; Mr. Scott Stecker, Sciaky, Inc.; Ms. Jeannette Geisler, International TechneGroup Inc. (ITI); Dr. Gary Harlow, Lehigh University; Dr. Peter Collins, Iowa State University
4:30 PM
The Effect of Build Orientation on Mechanical Properties of Selective Laser Melted Inconel 718
Dr. Glenn Bean, The Aerospace Corporation; Dr. David Witkin, The Aerospace Corporation; Mr. Tait McLouth, The Aerospace Corporation; Scott Sitzman, The Aerospace Corporation; Dr. Rafael Zaldivar, The Aerospace Corporation
5:00 PM
Post-processing Optimization of Laser Powder-bed Produced Inconel 625 for Improved Mechanical and Corrosion Properties
Dr. Eric Lass, National Institute of Standards & Technology; Dr. Mark Stoudt, National Institute of Standards & Technology; Mrs. Maureen Williams, National Institute of Standards & Technology
5:30 PM
Designing Titanium Alloys for Additive Manufacturing
Brian Welk, The Ohio State University; Samuel Kuhr, The Ohio State University; Prof. Hamish L. Fraser, The Ohio State University
See more of: Technical Program
<< Previous Session | Next Session >>