Additive Manufacturing II

Wednesday, September 15, 2021: 4:00 PM-5:40 PM
101 (America's Center)
Mr. Thomas Wingens, WINGENS LLC and Prof. Reinhold S. E. Schneider, Univ. of Appl. Sciences Upper Austria
4:00 PM
Powder Metallurgical Solution for a Complex Geometry Coupler Requiring High Dimensional Stability and Microstructural Uniformity through Heat Treatment
Dr. Craig stringer, PhD, Atlas Pressed Metals; Mr. Andrew Wright, Atlas Pressed Metals; Mr. Pete Imbrogno, Atlas Pressed Metals
4:20 PM
Optimization of the Post Heat Treatment of Additively Manufactured IN718
Dr. Alber Sadek, EWI
4:40 PM
On the Benefits of High Pressure Heat Treatment Additively Manufactured CoCr
Mr. Derek L. Denlinger, Paulo
5:00 PM
Benchmarking of print properties and microstructures of 316L stainless steel DMLS prints
Mr. Lucas G. Gallant, BSc, University of Prince Edward Island; Dr. Amy Hsiao, P.Eng, University of Prince Edward Island; Dr. Grant McSorley, P.Eng, University of Prince Edward Island
5:20 PM
High Pressure Heat Treatment for L-PBF Hastelloy X
Mr. Chad Beamer, MS, Quintus Technologies; Mr. Derek L. Denlinger, Paulo; Mr. Suraj Rao, Velo3D; Dr. Christina Dinh, University of Arizona
See more of: Technical Program
<< Previous Session | Next Session >>